Show status INP16 module

Moderators: Koen, Maarten, marc, Nico

Post Reply
Message
Author
Jochen Knoops
Posts: 2
Joined: Mon Aug 19, 2019 7:05 pm
Contact:

Show status INP16 module

#1 Post by Jochen Knoops » Tue Sep 03, 2019 9:37 pm

Hi there ..
I installed a normal open contact that closes when my garagedoor is completly open ... Is there a way to show this in the QbusCloud ?
For now i used the monostable in the Qbus System Manager wich changes status but i can't get it in the QbusCloud.
Is there another way to work with this kind of contacts ?

User avatar
Koen
Site Admin
Posts: 66
Joined: Wed Aug 29, 2018 1:26 pm
Location: Belgium
Contact:

Re: Show status INP16 module

#2 Post by Koen » Sat Sep 07, 2019 6:17 am

The monostable output is not available in the cloud, You should change this output to bistable.

Jochen Knoops
Posts: 2
Joined: Mon Aug 19, 2019 7:05 pm
Contact:

Re: Show status INP16 module

#3 Post by Jochen Knoops » Mon Sep 09, 2019 9:00 am

I would like to see the status of that contact (Same as a magneticcontact) .. If i use a bistabiel how does the status than changes when it's open ?

User avatar
Koen
Site Admin
Posts: 66
Joined: Wed Aug 29, 2018 1:26 pm
Location: Belgium
Contact:

Re: Show status INP16 module

#4 Post by Koen » Wed Sep 18, 2019 6:16 pm

You can configure your input as N/O then, when the contact is closed, your Bistable will be on, otherwise it will turn off.

Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests